|
|
|
|
|
|
The POWER SYSTEM box is the easiest to install in the market. It only takes a few minutes : the box is fitted with connectors that can be connected between the computer and the injection system. The installation therefore requires no mechanical skills.
However if you feel it is complex, you can benefit from the competencies of our distributors.
|
Consult the assembly instructions :
|
|
|
|
|
|
|
|
1 / Open the motor’s hood, disconnect the negative battery (-).
2 / Remove the plug from the injection calculator.
3 / Slide the top part of the plug and free the rubber cover.
4 / To identify wires. Always check the plug number on the calculator plug.
5 / Identify wire NUMBER 15 and cut it
.
6 / Weld the RED wire of the additional box on the part going to the calculator.
7 / Weld the WHITE wire of the additional box on the remaining part, insulate the two weldings with some heat shrinking wrapping.
8 / Identify the wire NUMBER 2. Remove the insulation on 1cm and weld on it the BLACK wire of the additional box, then insulate the splice.
9 / Identify wire NUMBER 19. Remove the insulation on 1cm and weld on it the YELLOW wire of the additional box, then insulate the splice.
10 / Identify wire NUMBER 16. Remove the insulation on 1cm and weld on it the BLUE wire of the additional box, then insulate the splice
.
WATCH OUT make sure the genuine rubber cover is well waterproof.
|
|
|
|
|
|
